Notes on Polarised Light Filters

Polarised light filters are used to detect stress in a non-destructive testing method in kilnforming.  The use of the filters is described in this blog. To produce consistent reliable results, there are certain conditions.

 The light source needs to be diffused in such a way that it is even across the viewing area.  An intense, single point light makes it difficult to determine the relative intensity of apparent stress. Another tip is that you can use your phone or tablet as a source of diffused light and as the bottom filter.  It emits polarised light, meaning only a top filter is needed.

Stress halos from broken and fused bottles

 It is important that the glass being tested is of the same temperature throughout to get a meaningful result.  This was emphasised to me when I was running a series of tests. I got in a hurry to test for stress to be able to start the next trial quickly.  I began to notice inconsistencies in the amount of stress I recorded for results of the series of tests.  Going back to the stressed test pieces, showed different stress levels when they were cold from when they were warm.

 The conclusion is that the glass to be tested for stress must be the same temperature throughout.  Even if it is only slightly warm, the apparent stress will be exaggerated.  It may be that the testing can only be done 24 hours after removed from the kiln.

 Stress will be more evident at points and corners.  The light will be brighter at highly stressed points, and even at extreme stress exhibit a rainbow effect.  More generalised stress is evident in a lighter halo.

Stress points in a drawing square illustrating the concentrated stress at corners

 It is much more difficult to check for stress in opaque areas of a piece.  If there are transparent areas, the stress will show there, although the stress may originate in the opaque ones. To be aware of potential stress in the combination of opaque glass, strip tests must be conducted on samples of the glasses. 

 Remember to include an annealing test too, as the stress test does not distinguish the type of stress.  If the annealing test shows stress, the annealing was inadequate. It is of course, possible that the glass is stressed because of incompatibility.  But the only way to determine that is to fire another test with a longer soak at annealing.