Showing posts with label Jointing. Show all posts
Showing posts with label Jointing. Show all posts

Wednesday 5 February 2020

Tucking Lead Came

It is most usual in many countries to butt lead cames against one another. In continental Europe the tucking of cames is more common. In this process, which has the advantages of speed and accuracy, the came is first fitted to the glass and then cut at the edge of the glass.

The first step is to cut the came to the appropriate angle to meet the lead to which it is to be joined. However before presenting the cut came to the joint, one end is lightly tapped with a small hammer to slightly curve the end of the came. This allows it to slip inside the leaves of the came to which it will be soldered.











The came is then shaped to the glass as normal. However, rather than removing the came for the next cut, the came is cut to the length of the glass, often using the glass as a guide. This end is then supported on the lead knife and tapped with the hammer to curve the end, ready for tucking into the next piece of came. Care is required so that you don’t crush the came and break the glass, nor miss the came and hit the glass or your fingers. With practice, there are few accidents.





Diagramatically, the tucked lead looks like this:




Tucking lead provides very accurate joints with no gaps for solder to fall through. Some argue it provides a stronger panel as the hearts of the jointed cames almost meet. The main immediate gain is quicker soldering.

Wednesday 27 November 2013

Disguising Joints in Fusing


One advantage of fusing over leading or copper foiling is that shapes impossible to cut as a single piece can be made from multiple pieces. However these joints often show up in the finished work.

You are always more likely to have the joints show when the cut coloured glass is on the bottom. The infra-red heat of the kiln elements goes through the clear glass to the coloured below, allowing it to soften first. As the glass underneath softens and pulls in, it allows the top glass to sink into the space. Upon cooling the seam is kept open even sometimes showing a clear line at the joints.

Putting the clear as the base and the jointed pieces on the top has a better chance of having the joints fully fuse together. There is no glass above to spread the pieces apart.

When you need the joints to be concealed, you can put a line of powder the same colour of glass over the joint. This line should be slightly rounded above the surface along the joint to account for the reduction in volume as it fuses. When it is two colours meeting, using powder of the same colour as the darker glass is most successful.

Fusing to a contour fuse for 10 minutes is normally hot enough, but taking the piece to a flat fuse – again for 10 mins - will certainly be enough to fully melt the powder into the joint.