Making Test Tiles

Creating samples or tests provides both references on firing profiles and knowledge of the characteristics of the kiln. 

General samples

 Sample tiles are normally a series of tiles with the same lay up but fired at different temperatures.  These are likely to be intervals of temperature from a sharp tack to a full fuse.  A suitable interval might be 10°C as it is easy to interpolate between these for a slightly different profile than the tiles show. This is the basic arrangement.

 You can make this more informative by including tiles in the same basic lay up but with hot and cool colours, opalescent and transparent, black and white, strikers, etc.  The addition of these will give a richer bank of information.

 Of course, these tiles must be labelled with glass types and code numbers and the temperature used.  This is not all the information required though.

 Many sample tile sets do not include the firing rate.  The heat work required to attain a specific profile is dependent on time, temperature and hold.  These are the time to get to the working temperature, the temperature, and the soak time.  If you do not record the ramp rate used, you will have incomplete information.  It is not that you have to record the entire schedule.  But the rates and any soaks on the way to the top temperature need to be recorded. This means you can take account of any slower rate of heating, any additional holds on the way up, and the length of the soak at top temperature.  Then when contemplating something more complicated than the conditions under which the tiles were made you have better information.

 It is a good idea to maintain a photographic record of the sample tiles to avoid storage problems.  These can be made from the individual tiles and photographed from several angles. 

 Another way of keeping records - without making tiles for each temperature - is to photograph the tiles through peep holes as the set temperatures are achieved.  This means the tiles need to be placed in the kiln so they can be seen from the peep hole. You will only have a physical sample for the top temperature. The other profiles will have a photographic record.  The firing conditions for these need to be recorded just as for the series of physical tiles.

 This photographic record may not be suitable for your way of working and so require making the sets of multiple tiles.  Both these methods provide a generalised record of heat work to achieve given profiles.  Note that you will need to prepare sample tiles for each kiln, as each has different characteristics. 

Specific samples

 However, there will be cases where the general conditions exemplified by the reference tiles are to be exceeded.  In this case you will need to make a sample specific to the piece you are planning.  This can be a general representation of the piece, or a scaled mock-up. 

 The general test tile may be small scale or relatively large.  It will contain only the components in terms of height and shape that will be in the planned, but more complicated piece.

 A more rigorous method is to make a full scale – or nearly so – mock-up of the piece. This is usually done in clear. Fire it to the proposed schedule to determine the exact effect.

  

Sample making gives confidence in preparing work for the kiln and scheduling to get the desired profile.