Softening the Tack Profile

Often people want a particular profile not provided by the schedules in the controller or the ones they normally use for tack fusing. The question arises as to whether to increase the temperature or extend the soak on a previously fired piece.

You can do either.

You can extend the time or increase the temperature. There are benefits and drawbacks with each.

Increasing the temperature is the choice for a quicker firing. But you have less control.  By increasing the temperature, you will certainly get a softer edge to the glass. You do not know until the firing is finished how much the glass has changed.

Extending the time means that you know a softer profile will be created simply by more heat work being put into the glass.  If you combine the extended soak time with peeking at intervals, you have much more control over the exact profile achieved.  Observation at 5- or 10-minute intervals after the target temperature is achieved, will enable you to get exactly the profile you want. Just advance to the next segment when that profile is achieved. 

The drawback is that the firing takes a little longer and you have to be present at the time the working temperature is reached.  You can schedule that by using the delay feature on your controller.

Note that on any re-firing of a piece you need to be aware that you are firing a single thicker piece rather than the original multiple layers.  This will require a more cautious rate of advance up to the softening point of the glass – generally around 540°C.  After that, the original rate(s), soaks and annealing can be used.

Of course, the considerations of temperature versus time can be applied to an initial firing as much as to a re-friing of a piece.

Observation is the best way to have precise control over the profile of your tack fusing.

Further information is available in the ebook Low Temperature Kiln Forming.