Slumping Breaks

“Why does my full fused disc break when I slump it?”

There are several possibilities. The two main ones are annealing and ramp speeds.

Inadequate annealing in the fusing stage can lead to a very fragile piece when being re-heated.  If there is significant residual stress in the fused piece, it is much more sensitive to heat changes during subsequent firings whether full, tack, or slumping/draping. It is important to thoroughly anneal any piece at every firing.  If you are firing a different layup or contrasting colours and styles, you should check for stress using polarising filters.  

The slump – or drape – firing needs to be much slower in temperature rise than the fuse firing.  You now have a thicker piece which takes longer to absorb the heat evenly. 

If your piece is tack fused, it needs an even more slow rate of advance.  Sometimes this needs to be as though the piece were two to four times the actual thickness of the piece.  The more angular and pointed the tack fused elements, the greater the reduction in firing speed.  This post gives guidance on how the piece is designed and its thickness affects the rates and soaks in tack fusing. 

Further information is available in the ebook Low Temperature Kiln Forming.