Sunday, 29 March 2020

Trimming the Came on Site

There are a variety of reasons for the panel not fitting the opening easily. These can range from poor measurements through parallel, or trapezoidal openings to irregular perimeters of the openings.

In the cases of irregular openings, you can trim the edge cames if you have used 12mm (1/2”) or more wide came. The quickest way of trimming cames to fit the opening is to use a rasp or “surform” tool. The open nature of the teeth, allows the lead to fall away. It is much quicker than using a lead knife, and it puts less pressure on the panel.

No comments:

Post a comment