The
shape glass takes up during a drape seems to vary depending on
whether the glass is a square or a circle at the start. The square
often forms a taco shape before the “horizontal” ends soften and
fall, pushing the glass into four drapes. The angle of these drapes
will move more toward being straight down with additional time or
heat. Circular draped glass tends to form three drapes, which also
become more vertical with time and heat.
 |
| Early stages of a steep drape |
One
occasional problem with elevated moulds is that the draping glass is
“longer” than the mould is tall. Understanding
how the glass forms during a drape will help avoid this effect. The
glass drape
first
forms a curve as
it begins to drop, which
continues to be in place until it touches the mould. The rest of the
firing stretches the bow in the glass out.
If
there is no mould at
the bottom for it to
touch because
the mould is elevated,
the curve goes beneath the bottom edge of the mould.
If
the draping glass is longer than the elevated mould, the glass will
drape to the shelf and can creep under the bottom edge, trapping the
mould.
Alternatively if the mould is not elevated, the glass will
flatten on the shelf. The flattened ends will spread outwards, but
sometimes also creeping under the edge of the mould, trapping the
mould.
The
glass can be the correct length for the elevated mould, but the time
and temperature combination scheduled allows the whole drape to
stretch at the base, so the tips of the drape create one or other of
the trapping effects.
The
initial prevention of trapping the mould is to measure the length of
the drape. The size of the blank should be no longer than double the
length of the sides plus the width of the supporting top (the base of
the mould when stood open end up). This length is the maximum
diameter of a circle.
The diagonal of a square blank needs to be no
longer than that either. A
simple visual method is to establish a square corner directly onto the glass. Draw a 45°
angle line and measure off the length on the diagonal. Draw a right
angle line from the base to the point on the diagonal and you have
the length of the sides ready to score.
It
should be remembered that the glass will stretch to some degree
during the drape. The length of that stretch is dependent on the
temperature and time, so observation by frequent peeking will give
the results wanted by either skipping to the next segment or
extending the hold.
There
is more information on scheduling for drapes in the e-book Low
Temperature Kilnforming available from Bullseye and
Etsy.