Pink Confetti

Because confetti needs to be so heavily saturated with colour, some of the opalescent colours tend to devitrify. The pink is particularly prone to devitrification. There are several ways to prevent this: 

• cap (which can lead to bubbles), 
• add a devitrification spray, or 
• cover with clear powder or frit.

Covering completely with a fine layer of powder gives the most even result. Using frit can provide a speckled appearance that is useful in some circumstances.

This tendency of pink opal to devitrification applies to all formulations – Bullseye, Uroboros, S96 and float.

Bubble Reduction in Casting

There are several things that can be done to reduce the number and size of bubbles in casting.

• Fire higher - to 830ºC instead of 815ºC - and soak for at least four hours. This allows more bubbles to rise to the top and burst. If there are still more bubbles than wanted, increase the soak time.

• Stack the glass in the centre of the mould, allowing a few centimetres from the mould walls. This allows the glass to spread and flow from the bottom and up the sides, reducing the likelihood of trapping air. If you have more than one stack, keep the same space between the stacks as the mould walls.

• Make sure that the way you stack the billets or casting plates so there is a smaller space at the bottom of any cavity than at the top. The reverse allows the glass to soften and seal in the air in the space.

• You can construct a mould to make billets of the general shape of the final object. This of course, is much more work, needing two moulds.

• A major thing to avoid is the use of frit, especially at the bottom or deep in the mould as bubbles will collect around each piece and lead to a multiplicity of bubbles throughout the casting.

Disguising Joints in Fusing

You can use powder or fine frit to conceal the joints in fusing. This is most easily done before the first firing.

Fine frit can be made from the off cuts from your prepared glass, or you can buy powder of the correct colour. Where two colours meet use the darker or denser colour of frit or powder over the joint. Push the frit into place with a brush or stick to form a regular edge. You should heap the frit over the joint to allow for the reduction in volume when fused. This will not work as well on tack fusing as it does on full fused projects.

Example of frit "painting", the principal of which can be applied to glass pieces

An example of how frit can be brushed around glass pieces

Cleaning Magnets

When making frit in steel containers the metal fragments need to be removed using magnets. It can be very difficult to get the fragments off the magnets.

A solution has been suggested. Put the magnet into a small plastic bag before use. After cleaning all the metal from the frit, take the bag to the bin and remove it from the bag. The metal fragments will drop off into the waste bin, leaving a clean magnet.

Making Powder Designs Crisp

Tidying up powder designs is often a time consuming process using brushes. One way of cleaning the edges of lines and the bottoms of furrows in the midst of the powder designs is to use a modified keyboard vacuum.

I use a Miele vacuum sweeper –it has a variable suction - with a keyboard cleaning attachment.

I have modified the finest nozzle by putting the end of a ball point pen in it and filling in the remainder of the rectangle with blutac or a similar material. Turn the suction on the vacuum down to minimum and you can be very accurate about the amount of powder you remove to achieve crisp lines.