Core drill bits

Credit: JMbestglass.cn

Using core drill bits needs a drill press. It keeps the drill bit steady and avoids breaking the core which plugs the hollow part of the bit.

Oscillating a core diamond drill bit is not the correct procedure. Oscillating the bit creates two undesirable things.

• It breaks off the core that  is being drilled out, plugging the drill bit, and blocking the cooling water being pumped to the drill bit.  This means the bit heats up and loses some of the diamonds. Additionally, it can heat up the glass so much that it breaks. If you are not using a flushing head with your drill, you will need to raise the bit a little from time to time, allowing water to the grinding surface. 
• Starting at an angle or oscillating with a core bit wears out the sides of the drill bit more quickly than necessary. Core drill bits need to be applied directly and vertically. This is why core bits do best in a drill press. It holds the bit in a vertical position without breaking the core being drilled out, or prematurely using the diamonds higher up the bit.

Credit:  Lawson-HIS

There are generic drill presses available for holding Dremel-type craft motors and hand-held drills. They are inexpensive and make the drilling process so much more certain to regulate the pressure. It also makes an easier start without skipping over the glass. They are so inexpensive that a few holes without skipping will pay it.

Credit: Bhole ST1542 Pico Dril

Drill speeds should be varied according to the size of the hole being drilled. This is important with the high speed Dremel-type motors.  Larger holes need a slower speed than smaller ones. The rim speed of a small bit is nearer the rpm of the drill than a larger one, because the larger one travels a greater distance per revolution than a small one. A listing of recommended speeds is given in this blog.

Hollow core diamond bits are of two types:

•     One, where a heating process attaches the diamond, is called sintered in Europe and other countries.
•     The second, where the diamond is bound with resins, is called bonded in Europe.

They seem to have different designations in North America.

Bits of the first type are longer lasting, and more expensive. These can be “sharpened” with an aluminium oxide dressing stick to expose new diamonds and maintain their effectiveness.

Credit: W W Grainger.com

Bits of the second type wear quickly and should not be “sharpened” with a dressing stone. The normal wearing away of the bonding material exposes the new diamonds.  Dressing them wears away the diamonds that could be used in drilling.

Another advantage to core bits, is that a core drill grinds out much less glass from the hole than a solid drill bit, so it takes less time to drill a hole.

One disadvantage, especially on core drills of 5mm and less, is that the core needs frequent cleaning out of the cores that get stuck inside the drill bit. To maintain efficient and effective drilling, the core needs to be poked out from the bit from the base toward the drilling surface.  This applies whether water is being pumped through the core or not.  Without clearing the core, more pressure must be used to continue drilling, resulting in larger break outs as the hole is completed, and more breaks of the complete piece.