Soldering Copper Foil

Tip size
Soldering copper foil is ideally done with a smaller tip than for leaded glass. A 3/16" long taper tip is useful. Use the tip on edge rather than the flat side in order to minimize the iron's contact with the glass. Thus, the iron is held almost vertical. Foil heats up very fast and too much heat can crack the glass so the narrower the iron contact is the lower the risk.

Solder application
The solder is applied in one of two ways. The quickest method is to feed solder in on the thicker part of the shiny tip and let it flow down to the foil. The iron is held against the foil and pulled along the foil (which has been fluxed) at the rate that allows the solder being fed to the iron to produce a slightly rounded, shiny solder bead. Don't try and "float" the iron on top of the solder, be firmly down against the foil. This requires practice to match the speed of movement and the amount of solder fed to the iron.

Alternatively, you can do the patting method. This is easier to control and is done by soldering one tip-length, lifting the iron and soldering the next tip-length, barely re-heating the section just soldered.

Another variation is to place blobs of solder at regular intervals along the foiled and fluxed joint and then move the iron along the joint melting the blobs as you go. This avoids the tide marks at the cooling ends of the solder bead.