Showing posts with label Panel assembly. Show all posts
Showing posts with label Panel assembly. Show all posts

Thursday 15 August 2013

Assembling Foiled Pieces

Keeping foiled pieces together while assembling them prior to soldering is sometimes a problem.

If the panel is rectangular - or at least one with multiple straight sides - you can use short battens of the length of the sides. Nail or screw them down to a board so that about one half of the panel is contained. So if it is a rectangle, two sides will be enough. If it is six-sided ,three pieces would do.


An assembled piece illustrating the two battens - although with a leaded panel

For ease of assembly, a copy of the cartoon should be fastened to the board first and then the battens fixed on top of the cartoon. The pieces can then be placed against battens and held there with pins or nails until the next pieces are ready.
Illustration of the cartoon fixed by the surrounding battens

Some prefer to tack solder the pieces together as they foil. This can be done in combination with the use of battens. However, leaving the soldering iron idling while foiling and using it only occasionally is very hard on the iron's tip and your electricity bill. I prefer to assemble the whole and then solder all at once.

Illustration of placing pins all the way around an oval panel

For circular or irregular shapes a slightly different approach is required. You can use multiple pins or nails along the perimeter to hold the foiled pieces together. An alternative is to cut a piece of scrap window glass to the shape of the external perimeter of the panel. Hold it is place with nails or pins and proceed as with a rectangular shape.

Placing nails all the way around an irregularly shaped piece

Monday 25 March 2013

Assembly of Circles and Irregular Shapes.


Leading

Circles and ovals as well as irregular shapes significant support as leading often involves sideways pressures to fit the lead to the pieces of glass. Thus there are two main methods of support for the perimeter of the panel.

You can cut supporting pieces of glass to place around the perimeter. These need to be cut to the outside of the perimeter cut line. These supports must be in at least two or more pieces to enable the came to be put in place progressively. You then assemble the perimeter lead into it and continue to lead up as normal. The perimeter support can also be made from thin plywood or similar materials. This can be useful if the shape is to be repeated.

A simple means of supporting irregular shapes while leading is to place a number of nails around the inside edge of the cut line. There need to be enough to support each piece of glass with at least two nails. So you may need to add more nails to the initial set up. Build the panel without the perimeter leads. When the interior is assembled, put the perimeter came around the panel. Ensure the fully leaded panel fits within the dimensions of the opening. Then solder as normal.

Copper foil

The above methods can be used, but are often a bit heavy duty for copper foil processes. Instead of glass, timber or nails you can use more easily cut materials. Such things as stiff double walled cardboard, foam board etc., are suitable for light duty. You can cut the complete shape from these materials, but only good if no pressure is used in fitting the pieces.

If you are likely to repeat the shape and size, you can use plywood or similar materials. Build inside the shape and remove it when the whole is soldered on the first side.